Dolby Laboratories Multichannel Audio Tool DP570 - Manual (Page 78)

62 Dolby ® DP570 Multichannel Audio Tool User’s Manual
Configuring a Monitor System
A.1.4 Choosing Back Surround Speakers
The setting records the number of back surround speakers you have in your monitoring
system. The default is None. If this not correct, click either 1 or 2.
A.1.5 Emulator Reversion
This setting is not active in the current version.
A.1.6 Setting the Lt/Rt Gain
This is an input trim for the separate Lt/Rt Input . The default value is 0 dB. Adjust it using
the control shown in Figure A‐4 .
Figure A‐4
Figure A-4 Lt/Rt Gain Function
A.1.7 Configuring Dolby Pro Logic II
For a discussion of these features and their uses, see Section 4.21 .
To set up the DP570 for Dolby ® Pro Logic ® II:
1. Select a mode by pressing one of the buttons shown in Figure A‐5 . The default is
Movie.
2. In Music mode, use the sliders shown in Figure A‐5 to adjust the Center Width value
and Dimension values. The default for both is 0.
Figure A‐5
Figure A-5 Pro Logic II Controls
Note: Movie is the recommended mode for professional monitoring. The wide range of
possible choices in Music mode make it too complex and unpredictable to emulate.