Sim2 C3X1080 - Manual (Page 9)

C3X1080
ENGLISH
8
age displays (blue LED on). The projected image comes
from the input selected when the unit was last switched
off (Fig. 14).
If a very short time has passed since the unit was last
switched off, the lamp may not switch on because it is
too hot.
In such cases, wait a few minutes for the lamp to cool
down sufficiently.
SwITChINg Off AND RETURNINg TO STANDBY MODE
With the remote control: press .
With the keypad: press .
When switching off, the projector goes into stand-by mode
and stores the input selection at the time of switch-off.
The fans keep running until the lamp cools down (green
and red LEDs on), after which they automatically switch
off. Do not switch off the projector with the power switch
until the fans have stopped running.