SONOSAX STELLADAT II - Manual (Page 52)

52
6. Specifications
TRANSPORT
Track Format Conforms to DAT Standard
Head Rotary, 4 Heads
Tape Speeds Normal Speed Mode: 8.15 mm/s
Double Speed Mode: 16.3 mm/s
Fast Wind Time Max. 60 sec. with 120 minutes tape
Shuttle Speeds 1x, 2x, 3x, 5x, 9x, 16x
Jog Speeds 1x, 2x, 3x
Play Start Time Tape loaded: 1 sec.
Tape unloaded: 2.5 sec.
ELECTRONICS
Frequency Response 10 Hz - 21 kHz ± 0.3 dB (44.1 / 48 kHz)
10 Hz - 42 kHz ± 0.3 dB (96 kHz)
Dynamic Range > 90 dB
Signal to Noise Ratio > 90 dB
THD < 0.01% (-10 dBFS, 1 kHz)
Crosstalk > 100 dB (at 1 kHz)
Samplig Frequencies 44.1 kHz, 48 kHz, 96 kHz
Up / Down 1‰ supported
Tape Configurations 2 tracks, 4 tracks
Emphasis 50 µs/15 µs
Phase Difference Between
Channels
< 10° (20 kHz)
Signal Delay Time ~ 100 ms (read after write)
Level Meter Peak and VU meters
TIME CODE (optional)
Time Code Reader 24, 25, 29.97D, 29.97ND, 30D, 30ND frame rates supported
Time Code Generator 24, 25, 29.97D, 29.97ND, 30D, 30ND frame rates supported
JAM Sync function
REC RUN function
ASCII Communication Supported
Connectors XLR3-31 Active Balanced (transformerless), 4k Ω (INPUT)
XLR3-32 Transformer Balanced, 200 Ω (OUTPUT)
5p. LEMO (IN / OUT / ASCII TTL)
MIXER
Configuration 4 Channels
Phantom Power T12, 48V
Low Cut Filter 80 Hz (12 dB/oct.), 120 Hz (12 dB/oct.)
Panpots YES
Input Gain 0 - 70 dB
Level Pots Linkeable 2 by 2
Limiter ON/OFF selectable, activated 2 dBFS before clip