Teletronics WINC900A - Manual (Page 24)

24
Result Codes:
ERROR Connection does not exist.
CONNECT Successful return to on-line mode.
Q - Quiet Mode
The ATQ command controls whether result codes are sent to the host computer. If this command is
selected, the V and X commands may further modify the result codes.
Format:
ATQ0 Modem sends responses to host computer.
ATQ1 Modem does not send responses to host.
Result codes:
OK If ATQ0 is selected.
<nothing> If ATQ1 is selected.
ERROR Invalid argument.
S - Select Register
The ATS command selects a register for interrogation or modification in the current active profile.
Additional reads or writes to the register are accomplished with the ? or = commands, respectively.
The register remains selected until the next S command is given. The complete set of S register
commands is provided in Appendix B.
Format:
ATSn Select register <n>.
Result Codes:
OK Valid register selected.
ERROR Unsupported register.
? - Read Selected Register
The ATS? command returns the value of the selected register specified by the S command.
Format:
ATSn? Read value of register <n>.
AT? Read value of last selected register.
ATS? Read value of register 0.
Result codes:
Depends on S register contents. Numbers are in decimal format.
= - Write Selected Register
This command alters the value in the currently selected S register. The format of the parameter is
numeric or text, depending on the register being modified. Numeric values are specified in decimal.
If the S register is a text register, this command must be last on the command line.
Format:
ATS0=n Set register 0 to <n>.