Teletronics WINC900A - Manual (Page 25)

25
Result codes:
OK Valid parameter.
ERROR Invalid value for selected register.
V - Verbal Result Codes
The ATV command determines whether the device sends a numeric digit (terse mode) or an
informative text string (verbose mode).
Format:
ATV0 Use numeric result codes.
ATV1 Use text string result codes.
Result codes:
OK Valid argument.
ERROR Invalid argument.
Below is a listing of numeric and text string result codes:
Numeric Code Text String Response
0 OK
1 CONNECT
2 RING
3 NO CARRIER
4 ERROR
6 NO DIAL TONE
7 BUSY
8 NO ANSWER
X - Extended Result Codes
The ATX command determines whether the device enables extended result codes. All extended result
codes are enabled in the default settings.
Format:
ATX0 Enable only codes 0...4. Extended results are mapped as
appropriate to 0...4.
ATX2 Enable all extended result codes (default).
Z - Soft Reset
The ATZ command resets all parameters to the saved profile, aborting any active connection. If no
profile was saved, the device is reset to the default condition.
Format:
ATZ Perform soft reset.
Result code:
OK Command complete.
&C - Set DCD Operation