Teletronics WINC900A - Manual (Page 35)

35
APPENDIX B - S Register Summary
Register Function Range Units Default
S0 Rings to Auto-Answer 0-1 rings 1
S2 Escape Character 0-255 ASCII 43<+>
S3 Carriage Return Character 0-127 ASCII 13<CR>
S4 Line Feed Character 0-127 ASCII 10<LF>
S5 Backspace Character 0-127 ASCII 8<BS>
S7 Wait Time for Carrier 0-255 second 60
S10 Carrier Loss Disconnect Time 0-255 second 50
S12 Escape Prompt Delay 0-255 0.02sec 50
S14 Command Status Bitmap (read only)
S21 Equipment Status Bitmap (read only)
S22 Equipment Status Bitmap (read only)
S23 Equipment Status Bitmap (read only)
S50 Data forwarding idle time-out 0-255 0.1sec 2
S51 Primary Data forwarding character 0-255 ASCII 13<CR>
S52 Secondary Data forwarding character 0-255 ASCII 26<ctl-Z>
S53 Remote Party Address Char.String 0303030
S60 Idle Mode 0-1 0
S61 Idle Guard Time 1-5 0.1sec 5
S62 PLC Break Control Signal Length 0-255 10msec 30
S63 Enable the detection function or Listening
time 0-10 0.01sec 3
S-REGISTER DEFINITIONS :
The behaviors of WINC 900A can be adjusted via the AT commands and the content of register
to meet application’s requirement.
S0 Rings to Auto-Answer
Whether this unit will be able to answer the request for connection from the
remote caller automatically or manually is decided by the content of the
register 0.
S2 Escape Character
The value in register 2 maps to an ASCII code, a designated Escape
Character on the keyboard, which allows user to switch the operation mode
of the communication software back to command mode from connection
mode by holding the “Shift” key and press this key three (3) times.
S3 Carriage Return Character
S4 Line Feed Character
S5 Backspace Character
S7 Wait Time for Carrier