Thinklogical Camera Fiber-Link Manual - Manual (Page 14)

Extend Distribute Innovate
®
Camera Fiber-Link Extender Manual 10 Rev. E, June 2012
2.3. Technical Specifications
Each Thinklogical ® Camera Fiber-Link System is designed to the following specifications:
Electrical Cable
(supplied with
system)
CFL-3000: (1) CBL000007-002MR MDR-26 male cable, 2 meters
(1) KIT-000013 CAMERALINK W/RJ45 adapter/cable kit
CFL-4000: (2) CBL000007-002MR MDR-26 male CABLE, 2 meters
(1) KIT-000013 CAMERALINK W/RJ45 adapter/cable kit
CFL-5000: (2) CBL000007-002MR MDR-26 male CABLE, 2 meters
(1) KIT-000013 CAMERALINK W/RJ45 adapter/cable kit
CFL-6000: (2) CBL000007-002MR MDR-26 male CABLE, 2 meters
(1) KIT-000013 CAMERALINK W/RJ45 adapter/cable kit
KIT-000013 contains the following:
(1) ADP-000007 DB9M TO RJ45F Adapter
(1) ADP-000008 DB9F TO RJ45F Adapter
(2) CBL000001-002MR CAT5 cable assembly, 2 meters
For Adapter Pin-outs, see Appendix B, pg. 32.
Serial RJ45 (DB9M to RJ45 and DB9F to RJ45 adapters included)
Protocol Camera Link compliant (supports base/medium/full configurations)
Indicators
Two LEDs on each Camera Fiber-Link module:
Loss of Signal [LOS] (
Red ON if no signal)
( Red BLINKS if no camera is connected)
( Red OFF for good connection)
Power ( Green ON when power is applied)
Optical Cable
Fiber Count:
CFL-3000 (Base): 2
CFL-4000 (Full/Medium/Base): 3
CFL-5000 (Dual Base): 3
CFL-6000 (Dual Base RX): 4
Fiber Type: Multi-mode, 50/125um or 62.5/125um SC-type connectors
Fiber Connector Type: SC Standard / ST or LC Optional
Maximum Fiber Distance: See Appendix C, pg. 33
(Fiber Cable is either customer-supplied or ordered from Thinklogical)