Thinklogical Camera Fiber-Link Manual - Manual (Page 17)

Extend Distribute Innovate
®
Camera Fiber-Link Extender Manual 13 Rev. E, June 2012
the supplied CAT5 Cable Assembly (CBL-000001-002M). A DB9M to RJ45F and a DB9F to
RJ45F adapter is included with KIT-000033 (Fig. 6, pg. 13).
The serial port on the CFL-6000 varies from the CFL-3000, CFL-4000, and CFL-5000 systems
in that serial data from the PC is broadcast to both Camera Side units (transmitters). However,
serial data to the PC only comes from Camera 1 on the Camera Side (transmitter 1).

Serial Port communications are sampled at approximately 32 MHz going from the
Camera to Frame Grabber (RX, DSR, CTS)

Serial Port communications are sampled at 97 MHz going from the Frame grabber to the
Camera (RTS, TX, DTX).
The pin-outs for the Serial Port (RJ45 connector) are as follows:
Figure 6: Diagram showing the serial connections used as data terminal connections
and the included DB9 to RJ45 adapters. Other uses are also possible using each signal
to control a function at the camera end, such as lighting, sensors, etc.