Vinpower Digital SharkCopier Series - Manual (Page 16)

- 13 -
Step 2: Press ENT/Enter button to enter the Hard Drive Setup menu.
If the current source is not Hard Drive, you will see the screen below. Please press the
ENT/Enter button once to proceed.
Once you’ve entered the Hard Drive Setup menu, you will see following screen:
Step 3: Use the Up or Down button to locate the Load Partition menu; as shown in the
reference screen shot below.
Step 4: Press the ENT/Enter key to enter the Load Partition menu and you should see the
following screen.
You have a choice when loading your master disc content into the hard drive by pressing the
up or down button to find your desired partition naming method:
Option 1:
A new partition/image
Screen Shot (New Partition)
Option 2:
Overwrite one of the existing partitions/images (if any exists, including the reserved
partition/image)
Screen Shot (Overwrite)
Option 3:
Choose Auto Generate to have the system automatically generate a partition/image name
for you.
Screen Shot (Auto Gen)
Hard Drive Setup
1.Select Partition
Hard Drive Setup
2.Load Partition
Select HDD as source
OK?
Load Partition[160GB]
Load►New Partition
 160GB indicates the total available capacity of
the system’s hard drive – this number will vary
based on the size of the hard drive installed in
your duplicator.