Vinpower Digital SharkCopier Series - Manual (Page 20)

- 17 -
c) Please refer to the “Input Name and Number” section of “Chapter 2: Getting to know
your System” to enter the desired amount. Then press the ENT/Enter to continue on
to the next step.
Step 4: Once the Counter selection is submitted, you shall see the following Preparation
screen and the corresponding trays that do not contain disc(s) in them will
automatically be ejected:
If the above screen is displayed for more than 2 minutes after you have inserted
your blank discs, please check the quality of the discs.
Step 5: After you’ve placed your blank discs into the drives, please allow 5-10 seconds for
the system to detect them. After they have been recognized, you shall see the
following screen:
By default, the “Auto Start” setting is set to “Auto”. Therefore, if your system is not
completely filled with blank discs and there is no activity within 30 seconds, or if all
writers are filled and the system detects this, the system will start automatically.
Once the number of blank discs you inserted matches the number of discs
detected on the screen, press ENT/Enter (if you are not using Auto Start or wish to
speed up the process) to confirm and the following Processing screen will appear.
If the number of blank discs you inserted does not match the number of discs
detected on the screen, please give 10-15 seconds for the system to recognize all of
your blank discs.
Step 6: After 2 or 3 seconds of processing time, one of the following Copy progress screens
will appear. The left-hand screen is shown when “Specify Counter” is selected and
the right-hand screen is shown when “No Counter” is selected.
Preparing
Waiting for Blanks
Preparing
7 Disc Detected, Go?
Processing...
Please Wait
 The “7” indicates there are seven discs recognized by the Writer. Actual quantity may be
different depending on your machine. Actual quantity may be different depending on the
size of your machine or the number of discs you inserted.