Vinpower Digital SharkCopier Series - Manual (Page 30)

- 27 -
Change the Setup settings
Most of the internal settings and information is stored inside the Setup menu. To explore and
modify them is simple. Below is an example how to modify the “Auto Start” setting. Please note
that the default setup is set for optimal performance of the system, it is unnecessary to change if
you are satisfied with the outcome.
When you turn on your system, after it has booted up, you should see the following signifying
your system is ready.
Step 1: Use the Up or Down button to navigate to the Setup menu.
Step 2: Press the ENT/Enter button to enter the Setup menu and you shall see a screen
similar to below:
Step 3: Use the Up or Down button to navigate to the Auto Start setting.
Step 4: Press the ENT/Enter button to enter the Auto Start setting and you shall see a
screen similar to below:
Step 5: Use the Up or Down button to change the value to “Full”.
Step 6: Press the ENT/Enter button to submit the change. Once completed, you will be
guided back to the setting menu.
DUPLICATOR 3.37
12.Setup
Setup
1.Language
DUPLICATOR 3.37
1.Copy
Setup
2.Auto Start
Auto Start
Auto
Auto Start
Full
Setup
2.Auto Start