Vinpower Digital SharkCopier Series - Manual (Page 22)

- 19 -
Select the Duplication Speed
This process will allow you to adjust the duplication speed subject to your needs.
By default, the duplication speed will be set to the optimal speed for each format and setting.
However, under some circumstances, you may want to reduce the duplication speed. Those
circumstances typically are as follows:
 Poor Blank Media Quality. When your blank media quality is not good, lowering down the
duplication speed is necessary to make good copies.
 Poor Master Disc Quality. If your master disc condition is not good, lowering down the
duplication speed will greatly reduce the failure rates.
 Duplication Quality. Overall, the lower the speed, the higher the quality of your duplicates.
If you have time, it is a good choice to lower down the speed to produce the best quality
duplicates.
When you turn on your system, after it has booted up, you should see the following signifying
your system is ready.
Step 1: Use the Up or Down button to navigate to the Select Burn Speed menu.
Step 2: Press the ENT/Enter button to enter the Select Burn Speed menu and you shall see
a screen similar to below:
Step 3: Select the Correct Speed Type
There are different types of recording speed based on the disc format and source:
 HDD/CD to CD: Copying to CD-R/RW media from a pre-loaded CD partition/image
in the hard drive or a CD master disc in the Reader/Writer.
 HDD/DVD to DVD: Copying to DVD±R media from a pre-loaded DVD partition/image
in the hard drive or a DVD master disc in the Reader/Writer.
 HDD/DVD-DL to DVD-DL: Copying to Double/Dual Layer Recordable DVD media
from pre-loaded a DVD-DL partition/image in the hard drive or a Double/Dual Layer
DVD master disc in the Reader/Writer.
 HDD/BD-SL to BD-SL: Copying to BD-R/RE media from a pre-loaded BD
partition/image in the hard drive or a Blu-ray master disc in the Reader/Writer.
 HDD/BD-DL to BD-DL: Copying to Double Layer BD-R/RE media from a pre-loaded
BD-DL partition/image in the hard drive or a Double Layer Blu-ray master disc in the
Reader/Writer.
 HDD/BD-XL to BD-XL: Copying to Triple Layer BD-R/RE media from a pre-loaded
BD-XL partition/image in the hard drive or a Triple Layer Blu-ray master disc in the
Reader/Writer.
DUPLICATOR 3.37
7.Select Burn Speed
Select Burn Speed
CD to CD
DUPLICATOR 3.37
1.Copy