AEC WD 350 through WD3000 Dehumidifying Dryers - Manual (Page 34)

350-2100 cfm Dryers Chapter 5: Startup, Shutdown & Operation 33 of 58
Setting the Current Day of the Week, Hour and Minute:
1. Apply main power to the dryer.
2. Turn on the timer by sliding the left manual override switch to the "ON" position. The timer's
memory is cleared on power up.
3. Press and hold
MODE
until TIM ADJ becomes visible and SUN blinks.
4. Press or until the current day of the week is displayed.
5. Press to store the current day of the week in the timer's memory. The day of the week
indicator will stop blinking.
6. The current hour indicator should now be blinking. Press or to set the current hour.
The time is set in a 24-hour format.
7. Press to store the current hour in the timer's memory. The hour indicator will stop
blinking.
8. Press or to set the current blinking current minute indicator.
9. Press to store the current minute in the timer's memory. The minute indicator should stop
blinking.
Setting the start up time:
1. Press and hold
MODE
until PROG 1 is lit and the hour indicator is blinking.
2. Press or until the desired dryer start up hour is displayed. The start up time is set in a 24-
hour format.
3. Press to store the dryer start up hour in the timer's memory. The hour indicator will stop
blinking.
4. Press or until the desired dryer start up minute is displayed. The minute indicator should
be blinking.
5. Press to store the start up minute in the timer's memory. The minute indicator will stop
blinking.
6. Now the #1 output status indicator should be blinking. Press to turn the output to the ON
status.