ATL Telecom AM2 - Manual (Page 19)

ATL User Guide
AM2 G.SHDSL Modem
19
6
6.3.1.1 AT THE CO UNIT
The following outlines the steps that need to be followed to setup the unit as a CO Bridge unit.
6.3.1.1.1 STEP 1
From the options displayed, select the Bridge and CO Side options. Then click on the Next button
6.3.1.1.2 STEP 2
On the next screen, type in the IP Address, Subnet Mask, Gateway Address Host Name and WAN details. For
the example shown the following details would be entered.
Note:- Some ISP require the host name to be entered, although in most cases this field can be left blank.
Once you have entered the required details, click on the Next button.
Note at any point during the configuration section you can either, cancel the configuration, reset the
configuration or return to the previous screen by using the appropriate button located at the bottom of the
screen.