ATL Telecom AM2 - Manual (Page 74)

ATL User Guide
AM2 G.SHDSL Modem 74
7.3.2.1.4 BRIDGE
If the AM2 has been configured as a bridge, you can use the bridge command to setup the bridge parameters.
Move the cursor " >> " to the bridge command and press the enter key. The following sub menu will be
displayed.
>> gateway Default gateway
static Static bridging table
You can setup the default gateway IP via gateway command.
You can set up to 20 sets of static bridge using the static command. From the bridge menu, move the cursor
" >> " to the static command and press the enter key .
The screen will now display the following sub-menu.
>> add Add static MAC entry
delete Delete static MAC entry
modify Modify static MAC entry
list Show static bridging table
From the static menu, move the cursor " >> " to the add command and press the enter key .The screen will
now display the following sub-menu.
>> mac Configure MAC address
lan_port Configure LAN interface bridging type
wan1_port Configure WAN1 interface bridging type
wan2_port Configure WAN2 interface bridging type
wan3_port Configure WAN3 interface bridging type
wan4_port Configure WAN4 interface bridging type
wan5_port Configure WAN5 interface bridging type
wan6_port Configure WAN6 interface bridging type
wan7_port Configure WAN7 interface bridging type
wan8_port Configure WAN8 interface bridging type
list
Show static bridging table