ATL Telecom AM2 - Manual (Page 71)

ATL User Guide
AM2 G.SHDSL Modem
71
7.3.2.1.1 MODE
The modem can act as a router or as a bridge. The default setting is routing mode. You can change the system
operation mode by using mode command. Move the cursor " >> " to mode command and press the enter
key.
The following message is displayed.
Command: setup mode <Route|Bridge>
Message: Please input the following information.
System operation mode (TAB select) <Route>: Route
Use the TAB key to switch between the two options. Once the required option is displayed press the enter
key.
7.3.2.1.2 SHDSL
The SHDSL parameters can be setup by using the shdsl command. Move the cursor " >> " to shdsl command
and press the enter key.
The following sub-menu will be displayed
>> mode Configure SHDSL mode
Link Configure SHDSL link
n*64 Configure SHDSL data rate
type Configure SHDSL annex type
clear Clear current CRC error count
margin Configure SHDSL SNR margin
Mode
There are two types of SHDSL mode, STU-R and STU-C. STU-R denotes CO (Central Office) unit. STU-C
denotes CPE (Customer Premises Equipment) unit.
Link
The link type will always be 2-wire mode on AM2.
N*64
You can setup the data rate by a multiple of 64kbps where n is from 0 to 32. If you configure n i= 0, the
product will perform in adaptive mode.
Type
There are two types of SHDSL Annex type, Annex-A and Annex-B.
7