Epson EISA Desktop - Manual (Page 103)

3.
4.
5.
Grasp the drive from the front and pull it out.
Note
If you are removing an IDE hard disk drive from the
external bay and it is your only hard disk drive, you
must also remove the hard disk drive cable from its
connector on the main system board. First follow the
instructions in Chapter 4 to remove the subassembly.
After disconnecting the cable from the main system
board connector, replace the subassembly in the
computer as described in Chapter 4.
I
If the drive you removed was accessible from the front of the
computer, you need to reinstall the front panel slot cover
for that drive.
Turn the front panel so you are looking at the inside. Then
press the slot cover into the slot until it is seated in the tabs
on both sides.
Replace the computer’s front panel and cover as described in
Chapter 4; then follow the “Post-installation Setup
Procedures” on page 4-12 to update your configuration.
Installing and Removing Drives 6-13