Epson EISA Desktop - Manual (Page 51)

Using Special Modes
You can run the System Configuration program in various
special modes, including non-target modeling mode, by
starting the program with one of the two commands described
in this section. You can also use these commands to run the
program from a hard disk that runs MS-DOS if you copy the
necessary files to the disk first.
The SD command starts the System Configuration program
and allows you to run that program or any of the other utilities
available on the Access to other utilities menu. The CF
command also starts the System Configuration program, but
you cannot run any other utilities.
You can run the program(s) in different modes by including
one or more parameters on the SD or CF command line, as
described in the next sections.
Using the SD Command
If you want to run the program from your hard disk, first
follow the instructions under “Copying the Configuration Files
to a Hard Disk” below. Then follow these steps to use the SD
command:
1. To run the program from a diskette, insert the Reference 1
diskette in drive A and log onto drive A.
To run the program from a hard disk, log onto the drive and
directory where you copied the configuration files.
2. Type the following and press to start the program:
SD
Running System Configuration
2-21