Epson EISA Desktop - Manual (Page 115)

Running Tests
Follow these steps to run a test from the Execute menu:
1. Press or m to select Execute. You see the Execute
menu, such as the following:
System Board
Numeric Coprocessor
System Memory
Diskette
Drive A
Hard Disk Drive #l
Serial Port COMl
Serial Port COM2
Parallel Port LPTl
LPTl Printer Test
2. Press or to highlight the device you want to test
and press m. You seethe Repeat prompt:
How often to repeat test? 1
3. If you want to run the test once, press To run the test
more than once, type the number of times you want to run
it and press
4. If there is only one test for a device, the program begins
testing immediately. If there is more than one test for the
device, you see a submenu of test selections, such as the
following:
HARD DISK DRIVE(S) AND CONTROLLER
CHECK MEND
1 - Seek check
2
- Write, read check
3 - Read, verify check
4 - Run all above checks
0 - Exit
Running System Diagnostics A-S