H3C Technologies H3C S6800 Series Switches - Manual (Page 42)

34
ENDP configuration example
Network requirements
As shown in Figure 11 :
• Configure unicast-mode VXLANs on Switch A, Switch B, and Switch C to provide Layer 2
connectivity for the VMs across different sites.
• Configure ENDP to automatically set up VXLAN tunnels.
• Configure VXLAN IS-IS to advertise MAC reachability information and automate VXLAN tunnel
assignment.
Table 2 shows the VLAN and VXLAN mapping scheme.
Table 2 VXLAN and VLAN mappings
VMs VTEPs VLAN VXLAN
VM 1, VM 5 Switch A, Switch B VLAN 2 VXLAN 10000
VM 2, VM 6 Switch A, Switch B VLAN 3 VXLAN 10001
VM 3, VM 7 Switch A, Switch C VLAN 4 VXLAN 10002
VM 4, VM 8 Switch A, Switch C VLAN 5 VXLAN 10003
Figure 11 Network diagram
Configuration procedure
1. Configure IP addresses and routing settings:
# Assign IP addresses to interfaces, as shown in
Figure 11 .
# Configure OSPF on all transport network switches (Switches A through D). (Details not shown.)
2. Configure switch A:
# Enable L2VPN.