H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 64)

55
Information
channel
number
Default
channel name
Default output destination Description
1 monitor Monitor terminal
Receives log, trap and debugging
information, facilitating remote
maintenance.
2 loghost Log host
Receives log, trap and debugging
information and information will be
stored in files for future retrieval.
3 trapbuffer Trap buffer
Receives trap information, a buffer
inside the device for recording
information.
4 logbuffer Log buffer
Receives log and debugging
information, a buffer inside the device
for recording information.
5 snmpagent SNMP module Receives trap information.
6 channel6 Web interface Receives log information.
7 channel7 Not specified
Receives log, trap, and debugging
information.
8 channel8 Not specified
Receives log, trap, and debugging
information.
9 channel9 Not specified
Receives log, trap, and debugging
information.
Outputting system information by source module
Source modules refer to protocol modules, board drivers, and configuration modules which generate
system information. You can classify, filter, and output system information based on source modules. To
view the supported source modules, use the info-center source ? command.
Default output rules of system information
A default output rule specifies the system information source modules, information type, and severity
levels for an output destination. Table 4 shows the default output rules. The following describes the default
settings:
• All log information is output to the Web interface. Log information with a severity level of at least
informational is output to the log host, console, monitor terminal, and log buffer. Log information is
not output to the trap buffer or the SNMP module.
• All trap information is output to the console, monitor terminal, log host, and Web interface. Trap
information with a severity level of at least informational is output to the trap buffer and SNMP
module. Trap information is not output to the log buffer.
• All debugging information is output to the console and monitor terminal. Debugging information is
not output to the log host, trap buffer, log buffer, the SNMP module, or the Web interface.