H3C Technologies H3C WA2110-AG Wireless LAN Access Point - Manual (Page 17)

11
Tabletop mounting
To install the access point on a flat surface such as a table or desktop,
follow these steps:
1. Remove the access point from the mounting bracket.
WARNING!
When the RF antennas are transmitting data, keep the antennas away
from your face, eyes, and other exposed part of your body.
2. Place the access point on the table.
WARNING!
•
Do not mount the access point on any metal surface. Place it at a
position with good signal coverage.
•
Do not use or manipulate the access point near any uncovered
exploders or in any other explosive environments, unless otherwise
authorized by related functionaries.
3. Connect the Ethernet cable and, if you are using a power adapter, the
power cable to the corresponding port(s) on the access point.
Connecting the Access Point to an Access
Controller/Unified Switch
You can connect the access point to an access controller/unified switch
directly, or indirectly through an intermediate Layer 2 or Layer 3 network.
In either case, use a Category 5e cable for the connection.
You are recommended to install and configure the access
controller/unified switch before installing the access point. This is to
ensure that you can verify whether the access point works normally
immediately after you connect it. For instructions on configuring the
access controller or unified switch. refer to H3C WX Series Access
Controllers Configuration Guides, H3C WX Series Access Controllers
Command References and H3C WX Series Access Controllers
Web-Based Configuration Guide.