H3C Technologies H3C Intelligent Management Center - Manual (Page 583)

561
{
Always Effective—Shows whether the energy policy is always effective: Yes or No. This field
appears only when the execution mode is Periodical.
{
Validated at—Time at which the energy policy takes effect, in the format of YYYY-MM-DD
hh:mm:ss. This field appears only when the execution mode is Periodical and the Always
Effective option is not selected.
{
Expired at—Time at which the energy policy expires, in the format of YYYY-MM-DD
hh:mm:ss. This field appears only when the execution mode is Periodical and the Always
Effective option is not selected.
{
Description—Description for the energy policy.
When the energy policy is Start/Stop AP, the page contains an AP List to display all APs to
which the energy policy applies.
AP List contents
{
Status—Status of the AP: Online or Offline.
{
AP Label/Device Label—Device label of the AP.
{
SN—Serial number of the AP.
{
IP Address—IP address of the AP.
{
Model—Model of the AP.
{
Access Device—Model of the AC to which the fit AP connects.
{
Access Interface—Port number of the access device that connects to the fit AP.
{
Location—Location of the AP.
When the energy policy is not Start/Stop AP, the page contains a Fit AP Radio List and a Fat
AP Radio List to display all radios to which the energy policy applies.
Fit AP Radio List contents
{
Admin Status—Shows whether the fit AP is managed by WSM. Up indicates the fit AP is
managed by WSM and Down indicates the fit AP is not managed by WSM.
{
Radio ID—ID of the radio.
{
AP Template Name—Name of the AP template applied to the fit AP where the radio is
enabled.
{
Radio Type—Radio type: 802.11a, 802.11b, 802.11g, 802.11an, or 802.11gn.
Fat AP Radio List contents
{
Interface—Interface of the fat AP that connects to the radio.
{
AP Alias—Name of the fat AP where the radio is enabled.
{
Radio Type—Radio type: 802.11a, 802.11b, 802.11g, 802.11an, or 802.11gn.
Adding an energy policy
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Energy Policy Management.
The Energy Policy List page displays all energy policies.
3. Click Add.
The Add Energy Policy page appears.
4. Configure the following basic parameters of the energy policy: