Grass Valley 8964FS - Manual (Page 28)

28 8964FS Instruction Manual
Configuration
I/O Config Web Page
The I/O Config web page ( Figure 11 ) shows the rear input and output con-
nections to the module and allows you to name each input. Type the
desired input name (up to 11 characters) into the corresponding box. The
status of each input is indicated by the color of the display.
Note Outputs are not monitored in this application.
Status reporting of each channel input can be enabled or disabled by
selecting or deselecting the corresponding checkbox in the
Reporting
column. You may disable reporting for channels not being used if desired
to avoid error messages. This will cause the channel section to be grayed
out as shown in the example for Input 3 in
Figure 11 . The Reporting column
is also used when an SNMP monitoring application such as NetCentral is
installed.
Refer to Status Monitoring on page 48 for an explanation of the color coding
and using an SNMP monitoring application.
Figure 11. 8964FS I/O Config Web Page
Use
this
link