Grass Valley 8985FS v.1.2.0 - Manual (Page 22)

22 8985FSP/FS/PRC — Instruction Manual
Power Up
Table 1. Board Front Edge LED Names and Meaning
LED Indication Condition
FAULT
(red)
Off Normal operation.
On continuously Module has detected an internal fault.
Flashing Configuration problems. Check inputs and settings. Missing video.
COMM
(yellow)
Off No activity on frame communication bus.
3 Quick Pulses Locate Module command received by the module from a remote control system.
Short flash Activity present on the frame communication bus.
CONF
(yellow)
Off Module is in normal operating mode.
On continuously Module is initializing, changing operating modes or programming hardware.
Flashing Indicates rate of change of paddle controlled setting.
PWR
(green)
Off No power to module or module’s DC/DC converter failed.
On continuously Normal operation, module is powered.
REM OVR
(green)
Off
Not Used if present.
On
FRM1
(green)
Off Reference frame bus is disabled to frame on Genlock web page or no Genlock submodule is installed in slot 1.
On Reference frame bus is enabled on Genlock web page and Genlock submodule is installed in slot 1.
FRM2
(green)
Off Reference frame bus is disabled to frame on Genlock web page or no Genlock submodule is installed in slot 3.
On Reference frame bus is enabled on Genlock web page and Genlock submodule is installed in slot 3.
VID IN
(green)
Off Indicates no valid input signal is being detected.
On Indicates a valid input signal is being detected.
REF IN
(green)
On Indicates no valid reference signal is being detected or signal is not locked.
Off Indicates a valid reference signal is present and locked.