Grass Valley 8985FS v.1.2.0 - Manual (Page 54)

54 8985FSP/FS/PRC — Instruction Manual
Configuration
User Settings Web Page
The User Settings web page ( Figure 28 ) provides a save/load function for
configuration files and a way to recall factory defaults parameters and
signal names for the entire module.
Recall Factory Defaults and Names
Use the two button at the bottom of the web page to do the following:
• Set Factory Defaults – select the Set Factory Defaults button to recall factory
settings to the module. Defaults for all module parameters are listed in
Table 6 on page 75 .
• Set Factory Names – select the Set Factory Names button to recall factory
signal names to the module. Defaults for all signal names are displayed
on the I/O Config web page shown in
Figure 20 on page 39 .
Figure 28. Set Factory Defaults Web Page
Use
this
link