Genlock, Nce signal delay, Genlock web page – Grass Valley 8985FS v.1.2.0 User Manual
Page 57
8985FSP/FS/PRC — Instruction Manual
57
Configuration
Genlock Web Page
The Genlock web page (
) is present on 8985FSP + GEN
and 8985FS + GEN modules when an 8900GEN-SM submodule is installed.
Refer to the 8900GEN-SM Installation Manual available online for complete
details for configuring the 8900GEN-SM submodule.
This web page provides reporting status for the following genlock status
items:
•
Genlock – reports status of Genlock function as
Enabled
or
Freerun
.
•
Status – reports whether the reference input is
Locked
or
Not Locked
.
•
Firmware Version – reports the firmware version of the 8900GEN-SM
submodule installed on this 8985FSP module.
•
Hardware Version – reports the hardware version of the 8900GEN-SM
submodule installed on this 8985FSP module.
•
Ref Input Standard – reports the reference input standard as detected
by the 8900GEN-SM submodule that is connected to the Genlock Loop
on the 8900GFR-R rear module.
•
Ref Input Frame Rate – reports the frame rate of the reference input as
detected by the submodule.
•
Output Bus Frame Rate – reports the frame rate being output on the
frame bus.
•
Output Bus – reports the reference bus (Ref Bus 1 or Ref Bus 2) being
output from the submodule.
Genlock Control
The following controls are available for configuring the Genlock sub-
module:
•
Enable
or
Freerun
– select one of the radio buttons to enable the Genlock
submodule or allow the reference to freerun.
•
Input Standard Selection
– use this control to set the input standard needed
for the reference input. Refer to
•
Loop Bandwidth
– set this control for either fast locking (
Fast Lock
) to the
reference or for the lowest jitter performance (
Low Jitter
) depending on
the stability of the reference signal being used.
For example, if Low Jitter is selected and the Status is still
Invalid
after
one minute has passed, the input reference has excessive wander that
cannot be tracked in Low Jitter mode. Switch to
Fast Lock
and verify
Status is
Locked
after about 10 seconds.
Use
this
link