Video input web page – Grass Valley 8985FS v.1.2.0 User Manual
Page 40
40
8985FSP/FS/PRC — Instruction Manual
Configuration
Video Input Web Page
Use the Video Input web page (
) to select and monitor the video
input source to the module with the following:
Video Input Selection
This section provides the following for the video input signal:
•
Select Input Video
– select the input source from the rear module from one
of the following:
•
Coax
– corresponds to BNC input J9.
•
Fiber RX 1
– will be present when either the 1310NM-DRL or
1310NM-TRL submodule is installed, or
•
Fiber RX 2
– will be present when the 1310NM-DRL submodule is
installed.
•
Signal Name
– the signal name defined on the I/O Config web page will
appear in each field.
•
Signal State
– this field reports the status of the input video signal as
Present
,
Not Present
, or
Not Supported
(no fiber submodule installed).
Figure 21. Video In Web Page
Use
this
link