Installing boards into the aurora edit computer, Cabling boards to the breakout box, Cabling the sdr board to the breakout box – Grass Valley Aurora Edit LD v.6.3 Installation User Manual
Page 29: Cabling the hdr board to the breakout box, Cabling the sdfx/hdfx board to the breakout box
September 20, 2007
Aurora Edit Installation and Configuration Guide
29
Installing Boards Into the Aurora Edit Computer
Installing Boards Into the Aurora Edit Computer
All of the boards install in the Aurora Edit computer workstations and connect to the
corresponding Breakout Box. To install the board(s):
1. Disconnect power to your computer and remove the access panel.
2. Insert the board(s) according to the slot map in
Boards are installed in different slots depending on which workstation you have.
3. For the SDFX and HDFX versions, connect the audio adapter board to the I/O
board using the attached connector.
4. For the HDFX version, connect the Effects board to an internal power source.
5. Replace the cover on the Aurora Edit computer.
Cabling Boards to the Breakout Box
Follow the cabling instructions for your specific Aurora Edit configuration.
Cabling the SDR Board to the Breakout Box
Using the breakout cable provided with the Breakout Box:
1. Connect the 60-pin plug to the back of the Breakout Box; connect the other cable
end to the 60-pin plug in the board endplate.
2. Connect the three BNC cable connectors to the back of the Breakout Box; connect
the other cable end to the 9-pin D connector on the board endplate.
Cabling the HDR Board to the Breakout Box
To connect an HDR board to the HDR Breakout Box:
1. Using the connector cable provided with the Breakout Box:
a. Attach the 60-pin plug to the back of the Breakout Box.
b. Attach the other cable end to the 60-pin plug on the board endplate.
2. Using the three BNC connectors (labeled SDI IN, SDI OUT 1, and SDI OUT 2):
a. Attach the plugs to the back of the Breakout Box.
b. Attach the other cable end to the BNC connectors on the board endplate.
Cabling the SDFX/HDFX Board to the Breakout Box
To connect the SDFX and HDFX board to the Breakout Box:
1. Connect the attached cable from the back of the Breakout Box as follows:
• Plug the three BNC connectors to the SDI IN, SDI OUT A, and SDI OUT B
connections on the HDFX I/O board.
• Plug the 26-pin cable to the connector on the FX I/O board.
2. Connect the 26-pin audio cable from the Breakout Box to the FX I/O board.