Grass Valley Aurora Edit LD v.6.3 Installation - Manual (Page 43)

September 20, 2007 Aurora Edit Installation and Configuration Guide 43
Running the System Self-Test Manually
Running the System Self-Test Manually
You can run the System Self-Test anytime you want to test the system. Before running
the System Self-Test, make sure that the Aurora Edit program is not running.
To run the System Self-Test:
• Go to Programs | Startup | SystemSelfTest .
The Self-Test runs.
Troubleshooting the System Self-Test
On occasion, you may have a need to troubleshoot an error message from the system
self-test.
If any of the three tests fail, use this table to determine the cause and fix the problem.
If you see this message... It means...
Video card driver ___ is not supported.
CVFS client file system ___ is not supported.
DirectX driver version ___ is not supported.
Emulex LAN driver ___ is not approved.
Emulex SCSI driver ___ is not approved.
QLogic LAN driver ___ is not approved.
QLogic SCSI driver ___ is not approved. You have an incorrect version of one of the drivers installed on
your system.
1. Insert the Aurora Edit CD into the CD-ROM drive on the
workstation.
2. Navigate to the Drivers directory.
3. Install the latest driver.
Contact your Customer Service Representative for further details.