Grass Valley CONTROL Center CameraMan Rev.B - Manual (Page 17)

Page 14 Installation and Operations Manual
Knobs, Buttons, Slide Controls And Displays
Look at the top of your Camera Control Unit. It is divided into four sections: the knobs (left), the buttons (lower-middle), the slide
controls and joystick (right), and the LCD display (upper-middle).
Left Side: Knobs and Buttons
▼ Focus Control – Used to manually adjust the focal point of the lens.
▼ Power Switch – Press to turn the CONTROL Center on and off. Red LED lights when
power is ON.
▼ Auto Iris – Press to turn on. The active (selected on Home screen) CameraMan camera
will automatically adjust the IRIS and GAIN (IRIS only on 3-CCD cameras) to maintain a
constant video level. The auto iris light illuminates when active.
▼ Manual Iris – Used to manually adjust the camera’s IRIS to brighten and darken the video
picture. Range: 0(closed) to 31 (3-CCD), 0 (closed) to 16 (1-CCD)
Middle: Buttons
▼ Upper Section: Function Command Buttons – Used for LCD screen navigation.
As menus are called up and displayed, the functions for that menu appear above the
function command buttons. Activate the desired function by pressing the button.
Under the function buttons are the menu access buttons:
• HOME – Displays camera data and switching status.
• MENU – Displays menus allowing you to change Camera settings.
• SETUP – Displays menus enabling you to adjust Camera and CONTROL Center setup.
• BACK – Displays the last menu you were viewing.
▼ Middle Section: autoTRACK Views – Used to store/recall 10 custom views and five preset
autoTRACK Views: Left, Tight, Mid, Wide, and Right (autoTRACK model only).
▼ Lower Section: Numerical keypad – Used to store/recall location presets, select
video/audio input/outputs, select a camera for control in a multi-camera network, and to
Enter and Clear information found on the LCD display.
Upper
Section
Middle
Section
Lower
Section