Grass Valley CONTROL Center CameraMan Rev.B - Manual (Page 30)

Customize Your CONTROL Center Page 27
CONTROL Center Setup
Setup CONTROL Center Menu (SETUP > CTRL CENT)
Address Menu: Display Path: SETUP > CTRL CENT > ADDRESS
The CONTROL Center requires a unique address. To set an address (range), key in the address
number on the numeric keypad, then press Enter.
The Default address should work fine in most applications. If the address you type in
is invalid or the CONTROL Center is locked, then an error screen appears.
Beep Setting: Display Path: SETUP > CTRL CENT
Press the function command button to turn the audible beep on or off. The beep occurs when
location presets or autoTRACK views are being stored. Default is ON.
Lock Setting: Display Path: SETUP > CTRL CENT
Press the function command button to prevent setup changes and preset storage. This makes
the CONTROL Center "read-only". Default is OFF.
Refresh: Display Path: SETUP > CTRL CENT
Press the function command button to toggle the LCD refresh on or off. When set to OFF, the
Control Unit will not continually update its values, reducing the amount of communications to
the camera. Default is ON.
Setup Poll Cams Menu (SETUP > POLL CAMS)
Press the function command button under Poll Cams and the system polls the network and
displays ROM version information of the devices and their positions on the network.
Where you see *NPD*, that means there is no camera recognized at this address.
Setup CONTROL Center Menu
The CONTROL Center SETUP menus enable you to configure how the Control Center Control Unit communicates with your network
of cameras.