Grass Valley Trinix NXT v.3.3.1 - Manual (Page 317)

Trinix NXT — Installation and Service Manual 317
Configuration
Reclocker: (TRX-NXT-512x512): This column lists the following:
• “L” = The monitor output board is locked to (and is reclocking) the
signal.
• “B” = The monitor output board is bypassing (and not reclocking)
this signal. For more information about output monitor reclocking,
see Output Monitor Reclock / Force Bypass Settings
on page 206 .
For more information about output monitoring, refer to the manual sup-
plied with the control system.
Selecting the Input tab will display a menu similar to the one shown in
Figure 233 . This table shows the following information, for each input:
• Input signal presence (yes or no).
• Whether or not the input is in use (that is, whether or not it is cur-
rently switched to an output).
• If a proper input signal was present but has since been lost.
Figure 233. Inputs Tab
Selecting the Outputs tab will display a menu similar to the one shown in
Figure 234 . This table shows the status of each physical output (that is, the
number of the physical input switched to the output) and whether or not
the reclocking circuit is enabled for the output. For more information about
reclocking see Output Monitor Reclock / Force Bypass Settings
on page 206 .