Grass Valley Trinix NXT v.3.3.1 - Manual (Page 420)

420 Trinix NXT — Installation and Service Manual
Section 13 — Trinix Fiber Option
FO-33300 Fiber Optic Output Board
FI-33300 Fiber Optic Input Board
Outputs </= 32, using 16 dual Input SFP modules
Fiber Connector LC type connector (determined by the SFPs used)
Maximum Data Rate 3.0 Gb/s
Minimum Data Rate 270 Mbps
Data Reclocking Switch selectable on an output-by-output basis. The Output Board provides
reclocking for 270Mbps 1.485, and 3Gp/s or non-reclocking for other data
rates.
Output Jitter 3G: </= 0.3 unit interval (excluding incoming jitter)
270 Mbit and 1.5G: </= 0.2 unit interval
Output Optical Power Determined by the selected SFP module
Board Edge LED 6 green "Power" LEDs
1 red "Alarm" LED
1 yellow "In Use" LED
1 green "FPGA Ready" LED
Rear Panel LED 1 LED per channel
Inputs </= 32, using 16 dual Input SFP modules
Fiber Connector LC type connector (determined by the SFPs used)
Maximum Data Rate 3.0 Gb/s
Minimum Data Rate 270 Mbps
Input Optical Power Determined by the selected SFP module. It may be necessary to add input
optical attenuators to reduce the optical input power. This may be necessary
even with the SFP-13103G-M1DRX transmitter. Attenuators are usually
needed in CWDM systems, unless very long cables are used or other opti-
cal losses are present in the interconnecting cabling.
Board Edge LED 8 green "Power" LEDs
1 red "Alarm" LED
1 yellow "Active" LED
1 green "FPGA Ready" LED
Rear Panel LED 1 LED per channel