Grass Valley Trinix NXT v.3.3.1 - Manual (Page 330)

330 Trinix NXT — Installation and Service Manual
Section 7 — Broadlinx Console Commands
comBusStart () Starts com bus polling (or any other com bus activity)
by releasing the bus.
Do not do this unless you acquired the com bus.
comBusStop () Stops com bus polling (and any other com bus activity)
by acquiring the bus.
No EsTributary activity can proceed till the com bus is
released.
consoleHelp (char *string) String (optional): If the string matches a help entry
uniquely that help entry will be printed.
If it matches more than one entry then all matching
entries will be printed with their signature (but not help
text).
Table 62. D
Command Arguments Detailed Description
debugFilterOff (unsigned int f) Turn off bits in the debug filter. f should be hex.
debugFilterOn (unsigned int f) Turn on bits in the debug filter. f should be hex.
deviceDrop (int frame, int slot) Drop a slave
deviceListShow (int verbose, int slave) Show information for all devices
verbose shows more detailed information for the
devices
verbose = 1 shows all extended version information
verbose = 2 shows inactive devices also slaveBoard is
a boolean that allows showing the device list on a slave
board.
deviceMasterShow (void) Show device master (polling task) statistics.
When this is called the time statistics are reset.
deviceShow (int frame, int slot, int slave) Show device information for the device in the frame and
slot.
slaveBoard is a boolean to allow showing the device
data even though all the fields are not valid on the slave
board.
deviceTimeShow (void) No Help Text (deviceMaster.cc)
Table 63. E
Command Arguments Detailed Description
esShow () No Help Text (esTributary.cc)
esTribShowProgress (int show) Show progress of firmware uploads on the console.
If show is 0 turn it on, otherwise turn it off.
Table 61. C
Command Arguments Detailed Description