HEIDENHAIN SHB Data Interfaces for HEIDENHAIN User Manual
Page 56
April 2010
6 – 57
6.6.2 Description of the machine parameters of TNC 406/407/415
Machine parameters
The following list contains the machine parameters for all software variants.
Since however, several machine parameters are only valid for a certain software or have been
introduced or eliminated as of a certain software version, there are columns with symbols for
differentiation.
Meaning of the symbols
= The machine parameter or entry value applies for all software versions of this control.
04
= The machine parameter has been introduced with a certain software version
(e.g. with version 04).
I04
= The machine parameter is inactive.
-
= The parameter does not exist on this control.
Explanation of the columns
A
= TNC 407 with NC software 243 07* -- (without digitizing function)
B
= TNC 415 with NC software 243 05* -- or 259 91* -- (without digitizing function)
C
= TNC 407 with NC software 243 02* -- (with digitizing function)
D
= TNC 415 with NC software 259 96* -- or 259 97* -- (with digitizing function)
E
= TNC 407 with NC software 243 03* -- (software equivalent to TNC 415B/425)
F
= TNC 407 with NC software 280 58* -- (special software)