HEIDENHAIN SHB Data Interfaces for HEIDENHAIN - Manual (Page 86)

April 2010 8 – 87
8.1.3 Error messages at the FE in the ME mode
In the ME mode, errors are displayed by the indicator lamps (LEDs) of the control buttons
blinking.
LED off
LED on
LED blinks
Indicator lamps Error message
Disk is missing or error in the electronics
Disk cannot be formatted, as it is currently being used
Disk is missing or not formatted
Disk cannot be copied, as a read/write process is active
External device not ready or not connected
Disk is missing or not formatted
Disk is missing or not formatted or no program is available
Program cannot be output, as data transfer via the TNC interface is in
process
Program cannot be output, as data transfer via the PRT interface is in
process
External device not ready or not connected
Disk is missing or not formatted
Disk is missing or not formatted
Program cannot be output, as data transfer via the TNC interface is in
process
Program cannot be output, as data transfer via the PRT interface is in
process
External device not ready or not connected
Disk is missing or error in the electronics
Table of contents cannot be output, as data transfer via the PRT interface
is in process.