Hongdian H8951 3G/4G Wi-Fi router - Manual (Page 90)

5 Router config H8951 3G/4G Router
(2014-07-01) - 74 -
RIP is an interior gateway protocol. In the national networks ( such as the current Internet ) , has a lot for
the entire network routing protocols. Only adjacent routers exchange information. If the communication
between the two routers do not go through another router , the two routers are adjacent. RIP agreement,
without the exchange of information between non-adjacent routers.
Routers exchanging information is all the information currently known to the router . That is its own
routing table. At a fixed time to exchange routing information ( such as every 30 seconds ) , then the
router receives the routing information to update the routing table.
RIP protocol "distance" also known as " hops " (hop count), because each through a router hop count is
incremented . RIP is considered a good route it through a small number of routers , namely, " a short
distance ." RIP allows a path can contain up to 15 routers. Therefore, the "distance" equal to 16 hop
which is equivalent unreachable. RIP visible only for small Internet.
---END
OSPF configuration
OSPF (Open Shortest Path First) protocol is one of the (Interior Gateway Protocol), the most
widely used IGP, for a single AS (autonomous system) in the routing decisions for large
networks. OSPF business can be based whether the user needs to be configured at the factory
H8951 3G/4G Router.
Step 1 Log-on WEB GUI of H8951 3G/4G router.
Step 2 Click “Forward > OSPF” to open “OSPF” tab, as Figure 5-55.