Logitek Electronic Systems JetStream Audio Networking Platform - Manual (Page 16)

RS-232 – (Installed on selected units only) Used in special installations for serial control of
a video router.
If a Second Generation DSP/Network card is installed in a First
Generation JetStream enclosure, NET 1 will be used for the ADMIN
NET connection. The primary audio LAN connection will be on
SURFACE port 3. The secondary audio LAN connection will be on
SURFACE port 4. Contact Support if you have any questions after the
upgrade.
Rear Panel Connections – Second Generation (s/n 200-299)
VGA – Used to connect a computer monitor with a VGA port. The VGA and DVI ports operate
simultaneously.
DVI – Used to connect a computer monitor with a DVI port. The VGA and DVI ports operate
simultaneously.
USB (3 ports) – Used to connect keyboards, mice, or portable media.
If a KVM switch is connected to the JetStream instead of a separate
keyboard, the computer will display an error message saying that the
keyboard was not found after the BIOS POST message. After 5 seconds, the
message will clear and the computer will continue to boot. The keyboard on
your KVM switch will function normally despite the error message.
AUDIO NET 1: Located on the DSP card. This is a gigabit Ethernet connection. When automatic
failover is implemented, this will be the primary audio network. As of this writing, this port is not
used.
Logitek JetStream MINI Reference Manual 16