Logitek Electronic Systems JetStream Audio Networking Platform - Manual (Page 34)

JSM-MIC IN: 4/8 input Microphone Preamp card. Assign an IO24A in AE Config to the slot
where this is installed and only assign the first 4 input pins in the software to inputs for a RJ card and
8 input pins for a DB card. Do not assign any outputs in the software to this slot.
To enable phantom power on the input, turn on the “Cue at Infinity” checkmark on the input in AE
Config. When phantom power is enabled on the input, the yellow LED on the input jack will turn
on. The green LED on the input jack will light when audio is present as confidence metering.
 TIP: If you choose to enable phantom power by using Cue at Infinity, the microphones
will turn cue on when potted down, which may engage monitor muting in some
studios. To avoid this, phantom power may be turned on by adding some assembly
language code in Command Builder or Command Library. The command is
documented in Appendix D, however we strongly recommend that only Logitek
Support add this to your system as assembly language programming is meant for
advanced users only.
JSM-AIN: 4 stereo/8 mono Analog Input card. Assign an IO24A in AEConfig to the slot where this is
installed and only assign the first 8 input pins in the software to inputs. Do not assign any outputs in
the software to this slot. The green LED will light when audio is present on the left and yellow LED
will light when audio is present on the right.
Logitek JetStream MINI Reference Manual 34