Logitek Electronic Systems JetStream Audio Networking Platform - Manual (Page 31)

Component Replacement
Card swap-out
If you need to swap a card with an on-site spare, you can simply unhook the blue tab from the
card, pull up on the card to remove it, insert the replacement and snap it in. Be sure to push the RJ-
45 or DB-25 connector firmly through the rear panel slot prior to inserting the card into the edge
connector.
Cards are fully hot-swappable. Rack rails are available from Logitek to make maintenance easier.
As the Engine config is stored within the JSM-DSP (“Surface”) card, when
swapping a JSM-DSP, the config will need to be reloaded before normal
operation can be resumed.
Logitek JetStream MINI Reference Manual 31