Elation Professional 700 II - Manual (Page 24)

Power Spot 700 II™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 24
FANS HIGH Reed out internal temperature
REG Maximum cooling fan velocity
LOOF Automatic cooling fan control
LOHI Low cooling fan speed  lamp off
ADJU CODE
xxxx
Use the code for entering the calibration menu (for
authorized persons only)
COL1 Calibration of the color wheel 1
COL2 Calibration of the color wheel 2
GOB1 Calibration of the gobo wheel 1
GOB2 Calibration of the gobo wheel 2
GOB3 Calibration of the gobo wheel 3
SH T Calibration Shutter: Top side
SH B Calibration Shutter: Bottom side
PRIS Calibration of the prism wheel
IRIS Calibration of the iris
POFS Calibration of the Pan-Offsets
TOFS Calibration of the Tilt-Offsets
CLRE Settings in the internal memory (super-user only)
ARES Adjust Reset (wheels stand still after the reset)
VTIL Software version Tilt-board
VTR1 Software version driver board 1
VTR2 Software version driver board 2
VTR3 Software version driver board 3
DBUG Function not yet in use
COAD CODE
XXXX Use the code for entering the calibration menu (for
authorized persons only)
COL2 Coarse calibration of the color wheel 2
COL1 Coarse calibration of the color wheel 1
DFSE Call on the default function values
FEED Pan/Tilt feedback (error correction) On/Off
EFLG Correction of faults
8.1 Setting/Changing the DMX Address
After applying power to the POWER SPOT 700™ the LED will display the fixture’s
current DMX address immediately after the reset sequence. If the fixture is not
receiving a DMX signal the display will flash continuously.
D001
To set or adjust a DMX address, please follow the procedure below:
1. Switch on the POWER SPOT 700™ and wait for the fixture reset process to
finished ('RESE' will flash in the LED while fixture is in reset mode).