Elation Professional 700 II - Manual (Page 57)

Power Spot 700 II™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 57
14.2 Changing Gobos
1) Be sure the effects module is removed and opened as detailed in the
previous section of this manual.
2) Genteelly lift and pull the gobo holder out of the center part of the wheel
hub to remove the individual holder. See the left image below.
3) Once the gobo holder has been removed the Gobo itself can be replaced
by remove the centric spring with a small screwdriver or gripping pliers. Be
sure to follow the gobo alignment instructions that are detailed on the
previous page of this manual (section 14.1).
4) Once the gobo has been exchanged replace the retaining centric spring to
hold the gobo in position.
5) Place the Gobo holder assembly back into the gobo wheel central hub. A
slight snap will ensure that the gobo holder has been correctly and fully
inserted back into the gobo wheel hub.
Notice: There must be no gap between the gobo holder assembly and the
actual gobo wheel. Be sure to check for a complete and secure fit.
14.3 Changing Color filters
1) Be sure the effects module is removed and opened as detailed in the
previous section of this manual (section 13.1).
2) Pull the Color filter holder carefully out of the central locking spring-holder.
Be sure to grasp the color filter by the metal frame and by the glass filter
itself.
3) Replace the colored filters as needed by inserting the replacements back
into the color wheel’s central retaining spring. If necessary you may use a
small flathead screwdriver to carefully lift the center retaining spring on the
color wheel up.
Notice: Please be sure the color filter holder is snapped in completely.
Failure to do so may result in damage to the color filter.