Elation Professional 700 II - Manual (Page 32)

Power Spot 700 II™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 32
8.9.9 Default Settings
DFSE
This function is used to restore all the factory default settings and presets.
Press the Enter button to confirm this operation or the Mode button to cancel
and return to the menu. When this operation is selected the LED will briefly
readout ok, then return to the previous function. The chart below details the
factory defaults.
Function Display Default Settings
DMX Address D001 D001
Pan reverse RPAN ON OFF 
Tilt reverse RTLT ON OFF 
Automatic lamp on LAAU ON OFF 
Lamp on via DMX DLOF ON  OFF
Display DISP D ON  REV
Cooling fan FANS HIGH REG  LOOF LOHI
Feedback FEED ON  OFF
8.9.10 Feedback ”APC”
FEED
The POWER SPOT 700™ is equipped with ”APC,” automatic position
correction. This function automatically corrects the Pan and Tilt movement
should the unit lose step or is obstructed and forced to lose step. Press the
Enter button to access the sub-menu. Use the Up and Down buttons to toggle
between “ON” and “OFF” and confirm once more with the Enter button or use
the Mode button to cancel the operation.
8.9.11 Error and Fault Corrections
EFLG
(These functions are reserved for authorized technicians only)