Elation Professional 700 II - Manual (Page 25)

Power Spot 700 II™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 25
2. Press the Mode button to access the main menu. Toggle through the menu by
pressing the Up and Down buttons until the display shows D001. Tap the enter
button to make changes to the address, the current three digit address will
immediately begin to flash.
3. While the current three-digit address is flashing, use the Up and Down buttons to
select adjust the address. Lock your new address into the unit’s memory by
pressing the Enter button. After the new address has been successfully stored
into the fixture’s memory the LED will briefly readout OK.
The DMX address is non-destructible and will remain in the fixture’s memory even
when the power has been switched off. Memory is backed-up and retained by an
internal power source with a five year shelf life.
8.2 Test Program
Test
The Test Program engages the fixture’s internal test mode. This function runs a
complete test procedure of all functions. Press Enter to launch the self-test or the
Mode button to cancel and return to the main menu.
8.3 Audio Program
AUDI
The Audio menu allows you to run a stand-alone audio program. This program can
run either fast (AFST) or slow (Aslw); Fast (AFST): When running in “fast” mode
every sound impulse will trigger a new step. (Aslw): When running in You may run
several fixtures together at once to achieve a synchronized light show running to
sound in a Master/Slave configuration.
Additionally you can choose a basic position for this audio chaser. Use either the
internal manual mode or an external DMX controller to set the desired Pan/Tilt
position. Confirm this setting in the SVPT menu by pressing the Enter button.
You can also set the size of the audio chaser in the SIZE menu. You have the choice
between: NORM (no basic position has to bee chosen), 'BIG', 'MIDL' and 'SMAL').
If you want to run several units in a Master/Slave system be sure designate your first
unit in the chain as the master. All others must be "Slave" Master = OFF. Notice:
The Audio function is only working if no DMX is connected.