Enviro EA800 - Manual (Page 13)

General Information
D-011-0152 9
System Configuration Parameters
The EA800 base unit requires certain system level information as outlined in Table 4.
Table 4 System Configuration Parameters
Parameter Selections Factory Default Description
Date Format • MM/DD/YYYY
• DD/MM/YYYY
MM/DD/YYYY Sets the desired date format for all event time stamps.
Time Format • 12-hour
• 24-hour
24-hour Sets the desired time format for all event time stamps.
Data Collec-
tion Fre-
quency
• 30 seconds
• 1 minute
• 5 minutes
• 15 minutes
• 30 minutes
• 60 minutes
5 minutes Sets the interval for collecting and recording data from the
sensors. The data collection frequency applies to all sen-
sors.The EA800 provides approximately 10,000 data
points to be collected regardless of the frequency
selected. The estimated time duration covered for each
data collection frequency is listed below.
30 seconds = 3.5 days
1 minute = 1 week
5 minutes = 1 month
15 minutes = 3 months
30 minutes = 6 months
60 minutes = 1 year
Buzzer • Enable
• Disable
Enabled Enables and disables the buzzer when an alarm limit has
been exceeded or a warning condition exists.
WARNING !
Selecting Disable for this parameter turns the audible
alarm buzzer off completely. No audible alarm tone
will sound when an alarm occurs if DISABLE is
selected.
RF Channel 11 (2405 MHz)
12 (2410 MHz)
13 (2415 MHz)
14 (2420 MHz)
15 (2425 MHz)
16 (2430 MHz)
17 (2435 MHz)
18 (2440 MHz)
19 (2445 MHz)
20 (2450 MHz)
21 (2455 MHz)
22 (2460 MHz)
23 (2465 MHz)
24 (2470 MHz)
25 (2475 MHz)
26 (2480 MHz) channel 16 Selects the ISM band radio frequency (RF) channel for
transmission between the wireless sensors and EA800
base unit.