How to use this manual – Enviro EA800 User Manual
Page 6
2
D-011-0152
How to Use This Manual
How to Use This Manual
This manual is organized into sections that guide you through the installation process, then describe how to use the
EA800 and change its programmed settings if necessary. Some troubleshooting guidelines are provided, and the
appendices contain forms for you to photocopy and use to record the programmed settings of the EA800 and the
monitoring system setup.
The manual presents EA800 programming procedures by showing you the sequence of menus and screens you
will see as you perform the procedure, and the keys to press to advance to the next screen. The example below is
the procedure for unlocking the EA800 base unit to allow programming.
The arrows on the drawing indicate the direction of procedure flow.
In all procedures, use the
keys to select menu options and to increase/decrease alphanumeric values for
programming options. Use the PREV and NEXT soft keys (F2 and F3) to move the cursor to the next digit when
entering numeric data.
The functions of the soft keys
change and are defined on the screen in the area above each key. If no
text is shown above a soft key, it means the key performs no function on the current screen.
“Keys” on page 6 describes the functions of each key on the base unit.
Note: For convenient reference, “Appendix A: Screen Maps” on page 75 contains maps of all menus and
screens.
Throughout the manual, text that appears on the EA800 base unit screens is shown like this: MONITORING
Key names are shown in text like this: F1
The current menu selection is highlighted on the screen by arrows on either side of the
selection, as shown in the example at right. On this MAIN MENU screen, the current selection
is Sensors.
Use the
or
keys to move the highlight to the desired menu item, then press
to make the selection.
Enter:
0800
F1
Step 1: Press the
F1
soft key.
Step 2: The
UNLOCK
screen
is displayed. Enter your
password using the arrow
keys.
Step 3: Press the
ENTER
key
F1
can be pressed at this time
to lock the unit.
F1 F2 F3