Adding a wireless humidity sensor – Enviro EA800 User Manual
Page 41
Installation
D-011-0152
37
Adding a Wireless Humidity Sensor
The Hysteresis setting helps prevent alarms from being set and reset continually if the environment is at or near
the alarm set point by providing an acceptable variance. For example, if
HYSTERESIS is set at 1 and the sensor High
Alarm Limit is set at +95, the sensor reading must decrease to +94 (+95 minus 1) in order for the humidity alarm
condition to reset to a no-alarm condition.
The humidity sensor also allows you to configure an alarm delay time if desired.
1.
Unlock the base unit if necessary to continue programming. See “Accessing the MAIN MENU for
2.
Select
SENSORS from the MAIN MENU and follow the steps in the following diagram.
3.
After you press the ENTER key, the
NEW WIRELESS SENSOR screen is displayed. The EA800 searches for new
wireless sensors, indicated by an arrow that moves from left to right across the screen. When an available
wireless sensor has been detected, it is listed in the
SELECT SENSOR screen as shown below.
4.
Use the arrow keys to select the sensor to be configured, then follow the prompts to configure all screens for
that sensor as shown in the following diagram.
F3
This is the start screen for the next
sensor to be added, if any.
Example shown, set values as
appropriate for your system.