Enviro EA800 - Manual (Page 21)

D-011-0152 17
Preparation
Before you begin installation, ensure that you properly plan the alarm system. During the planning phase you will
generate all the documentation you need to successfully install the EA800 base unit and sensors in the alarm
system. This is important because complete and accurate installation documentation aids in system maintenance
later.
The suggested preparation procedure is as follows:
1. Read and understand the entire manual. General Information provides important information required to
properly plan, install, and use the EA800. The preparation phase helps ensure that the EA800 system will
function as required.
2. Photocopy the pages of Appendix B: Planning Worksheet, Appendix C: EA800 Wiring Diagram (one for each
EA800 base unit in the system), and Appendix D: System Configuration Record to create a record of the
specific EA800 alarm system installation you are currently working on.
3. Draw a floor plan for the facility where you will install the EA800 alarm system. Identify important details such
as the coolers, doors, computer rooms, etc. An example is shown below.
Figure 8 Example Floor Plan
4. Locate the base unit where authorized personnel can readily access it. If required, consideration should be
made regarding a location that discourages unauthorized access. If using wireless sensors, locate the base
unit to minimize the wireless distance. Ensure that the desired mounting locations for the EA800 base unit and
each sensor comply with the environmental specifications listed in Table 13: Specifications.
CAUTION !
If the EA800 base unit will be connected to a remote alarm panel, do not connect
the base unit to the alarm panel until after sensor connection and configuration
is complete. Connecting the remote alarm panel before configuring the EA800
sensors will result in false alarms at the remote panel.
CAUTION !
Do not install the EA800 base unit in coolers or freezers.
CAUTION !
Use only wired sensors specified in this manual for the INPUT 1 through INPUT 4
connections. Unverified sensors may damage the EA800 or result in improper or
unreliable operation.
Cooler1 Cooler 2 Storage Room 3 Computer
Room
Rear
Entry
Front
Entry
Front Desk
Freezer 1 Freezer 2 Room 1 Room 2
Men's Room
Women's Room
Conference Room
Alarm panel
installation area