Enviro EA800 - Manual (Page 54)

50 D-011-0152
Viewing Sensor Settings
Viewing Sensor Settings
You can view the readings of each installed sensor on the MONITORING screen. To view details of a sensor’s
programmed settings and current readings on one screen perform the procedure shown below.
Note: The MAIN MENU screen shown in the example procedure is displayed when the system is locked. Sensor
settings may also be viewed when the system is unlocked.
Use the arrow keys to highlight the desired menu item.
Viewing Active Alarms
To view the current readings of a sensor with an active alarm:
There are six conditions that may be shown in the alarm screen:
■ Comm: Indicates that the wireless sensor is not communicating with the EA800.
■ High: The sensor's current reading is greater than the programmed high threshold.
■ Low: The sensor's current reading is less than the programmed low threshold.
■ Batt: The sensor's battery is low.
■ Cut: Supervised water sensors only: cable is cut or disconnected.
■ Fail: Indicates that the sensor reading is exceeding the known range of the sensor.
More than one alarm condition may be displayed. For example, if a wireless sensor detects a high reading and
then stops communicating with the base unit, the alarm log will indicate a Comm, High alarm. This type of alarm
can be logged only if the high reading occurred prior to the communication failure.
F1
to exit